Grounded Spray Adjuvant

Grounded Spray Adjuvant is specifically formulated to enhance the effectiveness of pesticides and fertilizers. Contains an active ingredient that helps improve the deposition of the ground and aerial spray applications. It is an excellent solution for hard-to-control weeds because it allows pre-emergent herbicide application to last longer. The Grounded Spray Adjuvant is proven to boost the absorption of soil-applied pesticides. It lessens drift and evaporation, ensuring that herbicides and other pesticides are providing the maximum performance. This adjuvant is a perfect addition to spray tanks since it decreases the scattering of droplets, keeping the droplet size consistent. It is most effective when used with herbicides in sandy soils, specifically soils that are low in organic content. Ideal for aquatic, industrial, agricultural, forestry, non-cropland, turfs, and municipal use. Available in a 2.5-gallon jug container.

DIRECTIONS FOR USE

FOR USE WITH PRODUCTS REGISTERED FOR: AGRICULTURAL, AQUATIC, FORESTRY, INDUSTRIAL, MUNICIPAL, NON-CROPLAND, ORNAMENTAL, RIGHTS - OF - WAY, TURF, AND OTHER USES.

The addition of additives to some pesticides, fertilizers, and tank mixes may cause phytotoxicity to the foliage and/or fruit of susceptible plants. Prior to the addition of GROUNDED to fertilizers and pesticides where the addition of surfactants is not specifically recommended but not prohibited by the manufacturer, the user or application advisor must have experience with the combination or must have conducted a phytotoxicity trial.

For ground applications of GROUNDED with ground applied pesticides, use 1 - 4 pints per acre in 5 - 30 gallons of spray.

For aerial applications of GROUNDED, use 6 - 16 oz/acre. A minimum of 1.0% by volume is recommended for Aerial and Low Volume spray applications.

DRIFTABLE FINE MINIMIZATION: For all applications - a minimum of 1.0% by volume (or 1 gallon per 100 gallons of spray mix) must be used.

NOTE: The above use recommendations are considered to be adequate for most uses. Some pesticides, however, may require higher or lower rates for optimum effect. Follow the pesticide label directions when this occurs.

CAUTION: Do not mix oxidizing agents unless oxidizing agents are in solution.

MIXING

Prior to any pesticide application all spray mixing and application equipment must be cleaned. Carefully observe all cleaning directions on the pesticide label.

Fill spray tank one-half full with water and begin agitation. Add pesticides and/or fertilizers as directed by labeling or in the following sequence:

1. Dry flowables or water-dispersible granules
2. Wettable powders
3. Flowables
4. Solutions
5. Emulsifiable concentrates

and continue filling. Add GROUNDED last and continue agitation.